.

.

Obnovljeno
Osetljivi na svetlost Tanjir, Zgodno Praktične osetljivi na svetlost Suv Film Generalno Važećim Mršava Svjetlo za Electroplating za Oplate Kupka za PCB Odbor

Osetljivi na svetlost Tanjir, Zgodno Praktične osetljivi na svetlost Suv Film Generalno Važećim Mršava

KM 6.03

Na skladištu
In stock

Više detalja

    Uključi prilagodljive KAPACITET : krug photoresist stanja je sjajno prilagodljiva kapacitet za drugim materijalom.GENERALNO VAŽEĆIM : Univerzalni se koristi u proizvodnji PCB odbora, zakačiti na PCB površinu da bude osetljivi na svetlost.RUPA POKRIVA SPOSOBNOST : Su osetljivi na svetlost suv film ima veliku rupu pokriva sposobnost.OPSEG PRIJAVU : Pogodan za electroplating, rupu pokriva i etching.KORISTI sa POVJERENJE : Pogodan za uobičajeni oplate kupanje, nema bora ili boja greška. 1. Univerzalni se koristi u proizvodnji PCB odbora, zakačiti na PCB površinu da bude osetljivi na svetlost. 2. Pogodan za electroplating, rupu pokriva i etching. 3. Velika rupa pokriva sposobnost 4. Sjajno prilagodljiva kapacitet za drugim materijalom. 5. Pogodan za uobičajeni oplate kupanje, nema bora ili boja greška.

Predložene specifikacije

    Specifikacija

    Condition:
    100% Brand New
    Weight:
    Approx. 55g / 1.9oz
    Size:
    Approx. 1 * 0.3m / 3.3 * 1.0ft
      :
    Package List:
    1 * Photosensitive Dry Film :
      :
    Operating Steps:
    1. Uncover the film, the photosensitive film is sandwiched between the two layers of film, first tear off one side, a little difficult to tear, try a few more :
    2. Then film, the copper plate can be slightly cleaned, flattened, try not to have bubbles :
    3. After the paste, the iron is slightly heated, not too hot, to fix :
    4. Print circuit board film, it is recommended to use film, you can achieve the highest fineness, if you do not require precision with sulfuric acid paper to print. :
    5. Exposure, put the printed pattern on the photosensitive plate, use ordinary energy-saving lamps for about 30 minutes, if there is an exposure machine for 1 minute, the sun has not been tried, it should be about 15 minutes, the exposure process is obvious, because the photosensitive The film changes color when exposed, and changes from light to dark blue. You will easily see your circuit diagram appear on the board. :
    6. Develop, remove another protective film, put it into the developer (developer is 1:
    100 water, 10 grams of water, 1 liter of water), and use a cotton swab to wipe the board with a little force during development.
    7. Etching, this needless to say etchant water saturated solution :
    8. After etching, remove the film, remove the film by 1:
    60 or 70, and soak the board for a few minutes.
    Obnovljeno

Izbor kupca